- Do you need a special pole for eyelet curtains?
- How do you make an eyelet by hand?
- How do you install eyelets without a tool?
- How much fabric do I need for eyelet curtains?
- Are curtain eyelets a standard size?
- Do eyelet curtains need to be double width?
- Do eyelet curtains look cheap?
- How do you line up eyelet curtains?
- How do you fit blackout lining to eyelet curtains?
- How do you hang eyelet curtains on track?
- Should curtains touch the floor or window sill?
Do you need a special pole for eyelet curtains?
In theory all poles can be used for eyelet curtains, however they do tend to glide more smoothly and are more popular on a metal curtain pole.
You can purchase some curtain poles specifically for eyelet curtains and rings are not supplied..
How do you make an eyelet by hand?
Outward Loop EyeletsCreate your hole with a tapered awl. … Whip stitch in wide stitches around the hole to hold it open.Use a buttonhole stitch, stitching away from the center of the eyelet. … Optionally, you can use slightly wider stitches and circle the eyelet twice with buttonhole stitches.
How do you install eyelets without a tool?
Securing the Eyelet without a Tool. Push the top eyelet piece into the hole on the right side of the fabric. Once you have created a hole in the fabric, take the top part of the eyelet and insert the male part of the piece through the hole. You may need to wiggle it to get it into place if it’s a snug fit.
How much fabric do I need for eyelet curtains?
For standard pencil pleat heading we recommend double fullness (multiply the width by 2). For eyelet curtains you need between 1.5 times fullness (adequate) and 2.25 times fullness (maximum). You will need to make sure you have an even number of eyelets on your finished curtains.
Are curtain eyelets a standard size?
There is no standard size of curtain eyelets. You can find a variety of curtain eyelets in many sizes to suit all curtain pole diameters, which can be listed as 25mm, 40mm, 50mm, and 66mm. For example, 25mm curtains eyelets can be found in 1.7″ inch for 44mm outer diameter, and 0.4″ inch for 11mm overall length.
Do eyelet curtains need to be double width?
You need to allow for both flat panels to be a minimum of one and a half times the curtain pole width. I personally think they look much better at double the pole width. … To work out the length (drop) for your new eyelet curtains. you will need to hold the tape measure at the top edge of the curtain pole.
Do eyelet curtains look cheap?
One the reasons eyelets are cheaper (and look cheaper) is because they don’t use as much fabric, so you lose the cosy fullness of pencil-pleat curtains.
How do you line up eyelet curtains?
Place the lining on top of the curtain with the header tape facing towards you. Insert your curtain hooks into the header tape pockets as shown. Leaving your eyelet curtains lying on the flat surface, thread your curtain pole through, and inserting two curtain rings between each pair of eyelets as shown.
How do you fit blackout lining to eyelet curtains?
HOW TO USE THE BLACK OUT EYELET ON EXISTING CURTAINSPurchase the Stuart Graham black out lining eyelet curtain in the correct size. … Lay your existing ready-made curtain face down on a clean, flat surface. … Match up the eyelets of both products. … Thread a single curtain pole through both eyelets as usual.VOILA! … TOP TIP.
How do you hang eyelet curtains on track?
Simply thread your pole through the loops on the tab top curtains or the eyelet holes. Keep one tab or eyelet either side of your end bracket to anchor the ends and prevent the curtain from sliding all the way across the window.
Should curtains touch the floor or window sill?
The fabric should just touch the floor or hover half an inch above. This is also a great approach for café curtains (short panels that cover only the lower portion of a window and hit the sill), which work well in spots like the kitchen and bathroom, where long drapes aren’t practical.